Where Can I Send Michatoya Machinist Tools In For Repairs

How to Repair Rivet Tools

by Tom Lutzenberger

Jupiterimages/Photos.com/Getty Images

"Rosie the Riveter" worked in a manufacturing plant during Earth War Two inserting and securing rivets between materials to connect them together. When Rosie ran into a problem on the assembly line, she needed a solution fast to proceed production moving on the domicile front end. The state of affairs is repeated in factories today when a rivet tool needs repairing. Knowing how to chop-chop fix the obstacle or blockage can save time, money and free energy -- and production proceed upwards.

Fixing a Hand Rivet Gun

Step one

Plow the rivet tool upside down so you can see inside the rivet olfactory organ. Confirm if a rivet needle is stuck inside and won't come up loose. Use a crescent wrench to remove the nose chip.

Step 2

Twist the nose bit off, giving you clearance to go at the jammed rivet needle. Use needle-olfactory organ pliers to grab the rivet needle and pull it out. Work the manus lever of the tool to strength the needle to move.

Switch to vise grip pliers if the needle won't release. Apply the pliers on the exposed needle stub. Fix the vise handle and squeeze the pliers so they lock on the needle. Agree the tool with one hand and twist the vise pliers with the other until the needle stub comes free.

Fixing and Automated Rivet Gun

Step 1

Bank check the rivet tip on the tool to ostend it is the right size for the rivets being installed. Check the air pressure if the tool is an air rivet gun to confirm the pressure is sufficient to work properly. Wait at the air supply valve to make certain information technology is positioned to "ON".

Step 2

Ready the air pressure level to see 100 psi (pounds per foursquare inch) if the air pressure is too low. Endeavor the tool again to come across if it works. Disconnect the tool's air hose if the tool still fails.

Step 3

Disconnect the rivet tool's stub collector bin fastened to the tool. Make clean out any remaining metal bits or pieces of rivet. Disconnect the cleaned out office with a crescent or socket wrench. Betrayal the silencer component in the collector socket and employ a shop rag to make clean the silencer parts. Reassemble the stub collector and secure the end cap.

Bank check the hydraulic fluid level of the tool if possible. Contact or call by phone your local rivet gun dealer for your brand of tool if fluid needs to be replenished internally.

References

Tips

Things You lot'll Need

Warnings

Writer Bio